# A source of wishes

**URL:** <https://forum.lapinbim.com/t/a-source-of-wishes/126>\
**Category:** General\
**Created:** [November 16, 2026, 6:49am UTC](https://forum.lapinbim.com/t/a-source-of-wishes/126 "2026-11-16T06:49:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Petri](https://forum.lapinbim.com/user_avatar/forum.lapinbim.com/petri/32/52_2.png) [@Petri](https://forum.lapinbim.com/u/Petri)\
**Post date:** [November 16, 2026, 6:49am UTC](https://forum.lapinbim.com/t/a-source-of-wishes/126/1 "2026-11-16T06:49:49Z")

</div>

When drawing a wall or placing an object, it is essential to position the **first point precisely relative to the existing drawing** , before starting the actual drawing or placement.

Could the first point use the same input methods available for subsequent points? For example, select an existing point as a reference, then specify either:

- A distance and direction.

- X and Y offsets, switching between them with the **space bar**.

Automatic snapping to endpoints and other recognised points should remain available alongside these methods.  
\*\*\*  
The previously suggested feature for positioning a window at a specified distance from a reference point is excellent, especially because that distance can be edited later.

SketchUp offers another useful interaction: **after clicking to place a point, you can still type an exact value to adjust the placement**.

It would be helpful to support both: entering a precise value immediately after placement and editing the reference distance later.

---

<div class="post-metadata">

**Author:** ![Ionut](https://forum.lapinbim.com/letter_avatar_proxy/v4/letter/i/da6949/32.png) [@Ionut](https://forum.lapinbim.com/u/Ionut)\
**Post date:** [November 16, 2026, 8:31am UTC](https://forum.lapinbim.com/t/a-source-of-wishes/126/2 "2026-11-16T08:31:11Z")

</div>

> [@Petri](#):
>
> SketchUp offers another useful interaction: **after clicking to place a point, you can still type an exact value to adjust the placement**.

Sure! Also helpfull when placing a drawing or model relative to the project origin.
